CBWI October 2001 General Lee Conversion

The conversion of this radio is simple. Remove the four 100 Ohm resistors from the solder side of the main circuit board. Be careful where the four resistors are soldered together.

Use a minimum amount of heat and remove the resistors strait up, otherwise you may damage the trace that they are connected to. In addition, the traces in this area are very close and could be bridged very easily.

Check your work before testing it out, then test it and compare it to the road map.

General Lee Solder Side Of Circuit Board

General-Lee-Solder-Side-Of-Circuit-Board

General Lee 100 Ohm Resistor Closeup

Click Here to Leave a Comment Below 0 comments

Leave a Reply: