Home Archives About CBWI Search Contact Us 2001 Web Issues 2002 Web Issues 2014 Web Issues 11 Meter Forum CB World Informer
©
United We Stand Plaque Review Of The Magnum 357DX Magnum 357DX Conversions MD-4 External S/RF Meter Adding MD-4 To Other Radios Editor's Message Magnum 357DX Photo Shoot Magnum 357DX Adjustments Adding Workman MD-4 To Mag. 357DX PanaVise Pedestal Mount
Adding The Workman MD-4 To Magnum 357DX
Adding the MD-4 to the Magnum 357DX is simple if you don't want the LCD meter to read any signal. The MD-4 external meter measures current and draws the voltage down to the LCD meter, thus the LCD won't read once the MD-4 meter is connected to the same signal feeding the internal meter. Remember, the LCD meter only has a real resolution of five segments. Once the MD-4 is hooked up, the internal meter won't be looked at again. If it's desirable to have both work, go to the article titled Adding The Workman MD-4 To Other Radios. You can add a 2.5mm jack Mouser Part # 161-1650 to the back of the radio to accept the MD-4 plug. Run a wire from the tip connection of the jack to the wiper of RV1 or RV8. It doesn't matter which potentiometer you connect to, they are tied together. The contact point is the single lead opposite the two on the other end of the potentiometer. Connect a wire from ground to the ring terminal of the 2.5mm jack. Once installed, turn the MD-4 adjustment fully clockwise and then calibrate the "S" meter as usual. To calibrate the RF meter, put the radio in FM and on a dummy load adjust the meter to the last line at the far right of the scale. The meter leads connect to a 13.8 Volt source either internal to the radio, an external power source, or a vehicle dimmer control. Bob F
Cover Page Janurary 2002 Web Edition Star Janurary 2002 Web Edition Star CB World Globe
© CB World Informer 1996 - 2015 Worldwide Rights Reserved
Adding Workman MD-4 To Mag. 357DX